The type=‘Custom’ for an actuator will not activate no matter which Avar or Kevent the SDK says works. Not sure why ThrustRevers is not a standard hydraulic type, but custom will work for our reversers. The issue we have is we can’t activate this actuator when we set our custom failures and so the pressure never goes away. See image as we have closed all three valves we use for failures (since there is no other possible way to create a failure) and the reverser continues to have pressure. This must activate to drain. We also flooded this Kevent to double check it’s nothing on our end.
Example in sdk ‘ThrustReversers’_n (>K:HYDRAULIC_ACTUATOR_ACTIVE_ON)
This topic has been automatically closed after 60 days of inactivity since it was marked as obsolete.
If there is important new information about this same report, you can use the “Request reopen” button below to ask the moderation team to review it again.
For other issues or broader discussion, please open a new topic in the appropriate category.
