Helicopter torque indicator needle cannot display values above 100

[b1e1n7e]

SU4 1.6.34.0

Hey @Boris

I just noticed the following. It seems like the white torque needles are now locked to 100% as well. Maybe this was accidentally introduced when limiting the purple needle to 100%.

When I first tested the fix in the beta I am pretty sure it worked for me, but now that I am out of the beta it seems to behave differently.

On the the screenshot you can see that despite having 120% torque, the white needles 1 and 2 are stuck at 100.

So basically the white needles should always display the corresponding engine´s torque, which can be higher than 100%. The purple needle is based on the collective position, which can only go to 100%.

Is it possible to open the bug report back up for this introduced bug or does it require a new one?

[Boris]

Hello @b1e1n7e

I created a new topic using your message from the other post, as this is a different issue.

It may be related to the fix, but since I’m not sure, I prefer to track both issues separately for visibility.

I was able to reproduce it, and you’re right, the needle should be able to go above 100.

I’ve logged a ticket in our backlog.

Thank you

Regards,
Boris

[b1e1n7e]

Hey @Boris

Thank you very much for logging it and creating the bug report.

[FlyingRaccoon]

Hello @b1e1n7e

This is fixed in SU5 Beta.
Let us know if this is good for you.

Regards,
Sylvain

[b1e1n7e]

Hey @FlyingRaccoon

I can confirm that both the purple and white needles do now move correctly.
Thank you very much.

[system]

This topic has been automatically closed after 60 days of inactivity since it was marked as fixed.

If there is important new information about this same report, you can use the “Request reopen” button below to ask the moderation team to review it again.
For other issues or broader discussion, please open a new topic in the appropriate category.