Redraw Water Polygons

Hello everyone, when redrawing water polygons, as the SDK says, it is not possible to overlap them.

“IMPORTANT! Polygons of the same water type do not merge! If you have overlapping polygons of the same type they will cancel each other out and create what appears to be an exclusion area, only without the correct distance field feathering. So, avoid overlapping polygons unless you are creating an exclusion area or they are different types.”

For my part, my workflow is the following: when I redraw a polygon large enough, since I cannot do it all in one work session I divide it into parts then where there is the joint I put on another polygon (with higher priority) to cover. The additional anomaly is that I cannot use the same type of “water” as the two below… in fact then in the final result this anomaly is very noticeable.

I ask you if anyone has found an alternative method to overcome this limitation.

Regards