It is as if “-AllowDebugger” is not respected.
Anyone else with similar issues?
Hello @simfan ,
Did you wait until the startup loading was finished?
Are you crashing when opening visual without any project (Continue without code) ?
Hello,
yes, this happens when attaching after even loading the C172… it dies after a couple minutes. Something was changed in the debugger logic?
Hello @simfan
Did you attach Visual while in flight?
Does the crash occur if you attach while in the main menu?
Regards,
Sylvain
If I am in the main menu, it happens after Fly Now. If I am in flight, it happens after a couple minutes or less.
In any case, it shouldn’t happen in either case,right? As soon as the red message disappears from the top, it should become available, so we can at least test our aircraft when initializing etc.
1 Like
Yes, we observe the same behavior.
This is being investigated.
Regards,
Sylvain
Still a problem in 1.8.9.0… just sayin’.
Issue resolved in 1.8.10.0 - thanks guys!
1 Like
This topic has been automatically closed after 60 days of inactivity since it was marked as fixed.
If there is important new information about this same report, you can use the “Request reopen” button below to ask the moderation team to review it again.
For other issues or broader discussion, please open a new topic in the appropriate category.