Bug description: Seems this variable is not settable. I setup the variables in a update code to see if they will work. No success.
If i am correct this will allow us to set the time for each flight. This way we can store an Lvar value in save state then use that to load in the next flight. This way free flight will actually make sense to do a pre flight walk around. I hope to see this fully implemented.
0.5 1 (>A:1:WEAR AND TEAR CHECK PROGRESSION:38,Percent Over 100) 0.5 1 (>A:1:WEAR AND TEAR CHECK PROGRESSION:39,Percent Over 100) 0.5 1 (>A:1:WEAR AND TEAR CHECK PROGRESSION:5,Percent Over 100) 0.5 1 (>A:1:WEAR AND TEAR CHECK PROGRESSION:9,Percent Over 100)
Technically you are in preflight as soon as you load at a ramp. So yes. And I tried to use logic to set this as well. Did you used the Simvars to set this? I will try that too.
I figure the point of this settable variable is so we can create our own wear and tear progression for free flight. Was that the intention? We really need this so we can save a bunch of time on wear and tear and so in preflight walk around shows actual wear from previous flights.
This variable is only the one that determines the user has interacted with the part long enough to show the confirmation showing the status.. nothing else, the ones that sets them as failed, percentage of wear, damaged, etc are read only.
As Simbol mentioned above, WEAR AND TEAR CHECK PROGRESSION is only intended to track the user’s progression when inspecting an aircraft part. It cannot be used to set a wear-and-tear value.
If you think this functionality should be available in the sim, you can create a new idea.
This topic has been automatically closed after 60 days of inactivity since it was marked as obsolete.
If there is important new information about this same report, you can use the “Request reopen” button below to ask the moderation team to review it again.
For other issues or broader discussion, please open a new topic in the appropriate category.