Version: 1.XX.XX.X
Frequency: Consistently
Severity: High
Bug description:
I have a runway (12-30) both starts are properly placed in the scenery editor. But selecting runway 12 always spawns the aircraft at the runway 30 start position. The runway 30 start correctly spawns at the 30 End of the runway. But i cannot get the aircraft to use the Runway 12 start position.
Repro steps:
Attachments:
@Boris upon further investigation, it seems to be following the wind. It ignores the selected runway start and uses the end that is facing into the wind.
It is and was disabled.
Hello,
What is your game version number ?
Regards,
Boris
It’s 1.4.13.0
Can you confirm that enabling the “ATC Enforce Flight Plan” option, as mentioned by @DementedCorn327 above, resolves the issue on your end?
Regards,
Boris
This topic has been automatically closed after 60 days of inactivity since it was marked as obsolete.
If there is important new information about this same report, you can use the “Request reopen” button below to ask the moderation team to review it again.
For other issues or broader discussion, please open a new topic in the appropriate category.
